Tester and analyzer

Checks Battery Voltage
– Your battery’s ‘rest’ voltage is an indication of battery health.

Checks Battery Starting Power
– A reading in the red zone indicates a problem !

Checks Vehicle Charging System
– Is the charging system causing the problem?

Use on any 12V system

For use on any vehicle with a 12V battery system – Any battery size, any charging system.

More than just a voltmeter, it’s a super fast recorder of instant volt drop during ‘engine’ cranking – the best indication of a starter battery’s ability to deliver power when the engine needs it most.

Once the engine runs it checks if the charging system is able to bring the battery back to full charge.

Standard features

Includes mounts for on road testing - rear panel can be demounted to fit temporary & permanent fixing mounts.

Cable straps & Velcro strips are included.

18 LEDS Indicate full cranking and charging range – from 7V thru 15V.

Light and water resistant – ideal for outside testing or carrying around in your toolbox.

CHARGE NOW!
WARNING FLASHER

Connect to the battery.
When device lights (flashing continuously) the voltage has fallen below the test level and battery has approximately 50% charge remaining.

Time to recharge!
PRECHECK: Device will confirm correct connection and if battery has charge by flashing 2-3 times, then switch off if voltage is above the test level.

THE SAE CONNECTOR

accessories are equipped with an innovative heavy duty connection system that provides a reliable weatherproof connection between OptiMate battery chargers to or between OptiMate accessories. The connection system is rated at 15 Amps, allowing safe use of high amperage accessories such as heated clothing / riding gear. Electrical connections between cable and connector pins are fully sealed and rubber sealing shrouds enhance the weatherproof rating of in-line connections.The connection system is compatible with standard SAE connectors that are gaining popularity world-wide as a battery charger inter-connector, and is widely used as a connector in heated riding gear.

THE PACKAGING

accessories are supplied in a unique tubular container through which the product is clearly visible. The tube is sealed with a red 'OptiMate' cap with a swivel hanging tab and secured by a label that contains information about the contents.
power accessories are identified by a three digit model number e.g. 100, 120, 130. Products with the same first two digits belong to the same group, e.g. 100, 101 are USB chargers, 120, 122 are LED products.
Find them displayed in shop on vertical hanging racks or on shelves / counter top either grouped in 5-packs or as single items.